Equalizer Type Pipe and OD Tube Dies
All figures show the No. 2 Bender with tooling needed for the specific bend. All tooling sold separately.
Bending Round or Square Eyes on Flat Stock
The Bulldozer Die illustrated above is designed for making round or square bends on stock up to 3/16″ thick and 4-1/2″ wide. The advantage of this die for sharp square bends, is that the stock can be easily removed from the machine by pulling a pin; thus round or square eyes can be made. Also, the die is ideal for making intricate bends on wire up to 1/4″ diameter. (Figure 13) |
Equalizer Type Pipe and O.D. Tube Dies
For Cold Bending 16 ga. thru 10 ga. O.D. tubing and sch. 40 pipe up to 180 degrees without the use of mandrel or filler. Tube sizes available 3/8″ thru 2″. Pipe sizes 1/4″ thru 2.” (Figure 14) Large Radius Bends or Coils on 3/8″ thru 2″ O.D. tube and 1/4″ thru 2″ sch. 40. (Figure 14) |