|
|
| Tooling Options : Equalizer Type Pipe and O.D. Tube Dies |
| All figures show the No. 2 Bender with tooling needed for the specific bend. All tooling sold separately. |
 |
| Bending Larger Diameter Rings or
Eyes |
| 2-1/2" and Larger Eyes or Rings may be made using the 20B1 Cast Cam
mounted over the 53B2 center pin. (Figure 12-1) |
Back to top
 |
| Bending Round or Square Eyes on Flat
Stock |
| The Bulldozer Die illustrated above is designed for making round or square
bends on stock up to 3/16" thick and 4-1/2" wide. The advantage of this
die for sharp square bends, is that the stock can be easily removed from
the machine by pulling a pin; thus round or square eyes can be made. Also,
the die is ideal for making intricate bends on wire up to 1/4" diameter. (Figure
13) |
Back to top
|
| Equalizer Type Pipe and O. D. Tube
Dies |
For Cold Bending 16 ga. thru 10 ga. O.D. tubing and sch. 40 pipe up to 180
degrees without the use of mandrel or filler. Tube sizes available 3/8"
thru 2". Pipe sizes 1/4" thru 2." (Figure 14)
Large Radius Bends or Coils on 3/8" thru 2"
O.D. tube and 1/4" thru 2" sch. 40.
(Figure 14-1)
|
Back to top
|
| 90 Degree Bends on Rigid Conduit,
Standard Size Pipe |
This "Rigid Conduit" bending die is used mainly by electricians for
quantity production of 90 degree ells. The capacity on this type of die is
1/2" thru 1-1/2" sch. 40 pipe. (Figure 15) |
Back to top
|
| Bending Reinforcing Bar |
Specifically Designed Dies for re-bar sizes though 1" Grade 40 make it
easy to bend fill-in mat and saddles as needed on the job. Mounts on bench
or rugged steel pedestal available. (Figure 16) |
Back to top
|
| Bending Scrolls |
Scroll Bending Dies form uniform single turn scrolls 2-1/2", 4" and 5"
diameter and one-and-one half turn scrolls 6-1/2" and 8" diameter. Hand
operated, forms complete scrolls in seconds. Capacity 3/16" x 3/4". (Figure
17) |
Back to top
|
