|
|
| Tooling Options : Basic Pipe, Bar, Eye Bolts, "U"s, Rings |
| All figures show the No. 2 Bender with tooling needed for the specific bend. All tooling sold separately. |
 |
| Bending Pipe and Conduit |
| Bends Cold, all sizes of standard pipe and conduit up to 2" inside
diameter. Makes a smooth even bend without flattening the pipe or
splitting the seam. Bends to any degree or to a continuous coil as
desired. Bends to 10 " radius on the 2" size, down to a 2" radius on the
1/4" size. Illustration shows a 1-1/4" standard pipe being bent to a
return bend on an 8" radius. (Figure 1) |
Back to top
 |
| Bending Eye Bolts, "S" Shapes, Etc. |
| Eye Bolt Bending Feature forms neat smooth Eye Bolts, "S" shapes, "U"
shapes, etc., of round or square stock up to 5/8", cold. By using a wider
Bending Dog and longer Forming Pin, flat stock up to 1-1/2" in width can
be handled. With standard equipment, Eyes and "U's" can be bent with 1/2",
5/8", 3/4", 7/8" and 1" inside openings. Special bushings for bending
larger than 1" eyes are available. Eyes 1-1/2" or 2" I.D. can be bent easily on 3/4" stock. (Figure 2) |
Back to top
 |
| Bending Angles, Offsets, Etc., of
Heavy Cold Stock |
| Bends Angles, Irregular Shapes, Offsets, etc., of round or square stock up to 1-1/4", or of flat stock up to 4-1/2" x 1/2". Gauges are provided for accurately locating the point of the bend and for gauging the degree of the angle desired. Illustration shows apiece of 2-1/2" x 3/8" stock being bent to a right angle. (Figure 3) |
Back to top
 |
| Bending Heavy Cold "U" Shapes |
| Bends "U" Shapes of 1-1/4" round or square stock, or of 4-1/2" flat stock,
cold. Self-locking Cam Shaped Dies for bending "U"s of 1-3/4", 2" and
2-1/4" inside spread are furnished with General Purpose Dies. These Dies
can be built up to any larger size desired by simply bending a piece of
flat stock around them. Illustration shows a "U" bolt being bent. (Figure
4) |
Back to top
 |
| Bending Sharp Square Bends on Wide
Flat Stock |
| Bends Sharp Bends to a right angle or less on 4-1/2" x 1/4" flat stock,
cold. This feature of the bender is used where a real sharp corner bend is
required. It can be used for making sharp offsets, stake pockets, sharp
cornered "U" clips, etc. Illustration shows a piece of flat stock inserted
ready for bending. (Figure 5) |
Back to top
 |
| Bending Rings and Coils |
| Rings and continuous Coils of any desired diameter can be formed as shown
in the illustration. The Forming ring may be a short piece of pipe of the
right diameter or a 20B1 Bushing can be purchased from our Parts Catalog.
The stock is fed along a distance of 1" or 2" after each pull of the hand
lever. (Figure 6) |
Back to top |
